As of today we’ve officially completed Wave One of the Shuttle project. I effectively took all the work we’d done so far, all the things we’d talked about and tried to come up with a cohesive solution. Just hammering page after page. I’m not really sure were it all came from, but I guess it was mainly due to the fact that we’d sat on this for so long that is was time we just dealt with it all.

I am so excited to see this in action. I can’t wait to get my hands on it. I knew that if I loved it so much, my wordpress users would too. Here are a couple of screen shots of the Shuttle project.

Read More

There is a couple ways of stopping Vision. First, go to C:\Program Files\Master Solution you should see a folder inside called Vision, open it and see a program called MEUCONF, open it and hit “Run Manually�?, and that should solve that problem.

Another way is by simple unplugging the RJ45 connector from the NIC (Or in English, disconnect the wire coming from the networking card.)

FOR WINDOWS 95/98/ME:
Deep Freeze is a VxD (Virtual Device Driver) found in C:\Windows\System\Iosubsys\persifrz.vxd.
So the only way for hacking it is using a boot-disk and deleting the file. Yes…there is more files in C:\program~1\hypert~1\deepfre~1 but those are obsolete to us. They have nothing to do with what we are doing.

Note: persifrz.vxd IS Deep Freeze. Hence, deleting it will kill it completely

If you can’t boot from the floppy because your boot order is not setup that way, and your teacher has password-protected the bios, you can always 1-pull the battery out of the motherboard 2- move the “reset jumper�? by the bios to reset it.

FOR WINDOWS 2K/XP:
You need to delete 2 drivers and 1 service (I’m sure you can figure out the the paths)

DepFrzLo.sys (kernel driver)
DepFrzHi.sys (filesystem driver)
dfserv.exe (service)
frzstate.exe (password dialog)
persis00.sys (password file and “on/off switch”)

You should be good to go.

You should take Questions/Comments to the “Comments�? section of this post.